FOV-16:16 channels video Data RS485 fiber converter
16 channels video Data RS485 fiber converter
16 channels fiber video multiplexer:FOV-16
Over View
fiber-optic video transceivers can simultaneously transmit 16 channels of 8-bit digitally encoded video / return or bidirectional data / unidirectional or bidirectional audio / Ethernet / Telephone / Dry contact over one multimode or single-mode optical fiber. These multiplexers are typically used in applications where the cameras have P/T/Z capabilities. Plug and Play design ensures the ease of installation and operation. Electronic and optical adjustments are never required. LED indicators are provided for instantly monitoring system status. Devices are available for either standalone or rack-mount installation ,which is suitable for different working environment .
PRODUCT CHARACTERISTICS
1.8-bit digitally encoded and non-compression video transmission
2.Directly compatible with NTSC, PAL, and SECAM CCTV camera systems and support RS-232, RS- 422, and RS-485 data protocols
3.Support any high-resolution video signal
4.Automatic compatible PAL, NTSC and SECAM video system
5.Power supply and other parameter state indication, which can monitor the operation condition of system
6.Support no-damage regenerative trunk of video
7.Constant input optical power, and large dynamic range ,no Electrical or Optical Adjustments Required .
8.Special ASIC design .
9.Industry-grade of operating temperature from -10 to 75 degrees, which is applied to the different working environment
10.Hot-swap function
11.Stand-alone type or card-type installed in 19’’ 2U or 4U rack-mount chassis.
Technical Specification |
|
Video channels |
16 channels |
Video bandwidth |
8 MHz |
Automatic compatible video system |
PAL、NTSC、SECAM |
Video input / output impedance |
75 Ω(unbalance) |
Video signal-to-noise ratio |
≥67dB |
Differential gain |
(10%-90%APL) DG <1% ( typical value) |
Differential phase |
(10%-90%APL) DP <0.7° ( typical value) |
Video connector |
BNC |
Fiber-optic Specification |
F/O connector: LC (SFP) Transmitter: Tx Power:-8~-3dBm Sensitivity:≤-22dBm Receiver : Tx Power:-8~-3dBm Sensitivity:≤-22dBm Transmission Distance :20KM (single mode) Operating Wavelength: TX1310/RX1550nm(Transmitter); TX1550/RX1310nm(Receiver) |
Specification of custom-made options |
|
Data |
Connector: Terminal Blocks Encoded type : RS485 / RS422 / RS232 / Manchester Data rate : 0 - 400Kbps BER: ≤10-9 |
Audio |
Connector: Terminal Blocks Audio input / output impedance :600Ω(Balance/ unbalance) Audio input / output voltage :2Vp-p ( typical value) Audio input / output level :0dBm ( typical value) Video bandwidth:10HZ~12KHZ Audio digital encoded bandwidth :24bit Audio signal-to-noise ratio: S/N≥95dB (weighted) |
Telephone |
Connector: RJ11 Bandwidth :8KHZ Features:Support call-showing function ;support H-F Operating mode : Point to point hotline mode / FXS-FXO |
Ethernet |
Connector: RJ45 Support mode : Half duplex or Full duplex Standards:IEEE802.3 Data rate : 10M / 100Mbps Bandwidth: 25M |
Dimensions :48.3(L)×22(W)×4.4(H) cm ( 19’’ 1U )
Operating Voltage: DC5V (we will offer external power supply from AC96-240V to DC5V for each unit )
Operating Temperature: -40℃ to +85℃
Storing Temperature : -55℃ to +85℃
Humidity: 0 to 95% non-condensing
MTBF : ≥ 105 hours
Warranty : 3 years
Application :
Intelligent Transportation System
Connection of Sub-network for Surveillance Center
Public Security Surveillance
High Way & Toll Station Surveillance
Industrial Closed Circuit Television Surveillance
Typical Application
PDH Multiplexer
SDH Multiplexer
E1 Converter
TDM over IP
Modem
PCM Multiplexer
Fiber Media Converter
Fiber Video Converter
fiber module
SFP fiber module
SFP+ fiber module
40G 100G module
PCM multiplexer
fiber Module
SFP+ fiber module
40G module
100G transceiver
fiber to ethernet converter
E3 DS3 to ethernet converter
fiber optical modem
TDM over IP
G.SHDSL modem
Ultra Low Temperature Freezer
Speed Reducer
Rehabilitation Equipment
Telecom Equipment